Aurora Service Manual

SiUS121737EA Wireless Remote Controller (BRC082A41W, BRC082A42W(S))
Remote Controller 128
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
The display shows the set fan speed.
ON/OFF BUTTON
FAN SPEED CONTROL BUTTON
TEMPERATURE SETTING BUTTON
DISPLAY /TEST
(INSPECTION/TEST OPERATION)
When the INSPECTION/TEST OPERATION button is
pressed, the display shows the system mode is in.
Press the button and the system will start. Press the
button again and the system will stop.
Press this button to select the fan speed, LOW,
MEDIUM or HIGH, of your choice.
Use this button for setting temperature.
TIMER MODE START/STOP BUTTON
TIMER RESERVE/CANCEL BUTTON
AIRFLOW DIRECTION ADJUST BUTTON
OPERATION MODE SELECTOR BUTTON
RECEIVER
OPERATION LAMP (Red)
TIMER LAMP (Green)
This lamp stays lit while the timer is set.
DEFROST LAMP (Orange)
Press this button to select OPERATION MODE.
This switch is readily used if the remote controller does
not work.
This receives the signals from the remote controller.
This lamp stays lit while the air conditioner runs. It
blinks when the unit is in trouble.
AIR FILTER CLEANING TIME INDICATOR LAMP
(Red)
Lights up when it is time to clean the air filter.
Lights up when the defrosting operation has started.
DISPLAY (SIGNAL TRANSMISSION)
This lights up when a signal is being transmitted.
DISPLAY , , , ,
(OPERATION MODE)
DISPLAY (SET TEMPERATURE)
This display shows the set temperature.
This display shows the current OPERATION MODE.
DISPLAY (PROGRAMMED TIME)
DISPLAY (SWING FLAP)
DISPLAY (FAN SPEED)
This display shows PROGRAMMED TIME of the
system start or stop.
FILTER SIGN RESET BUTTON
INSPECTION/TEST OPERATION BUTTON
EMERGENCY OPERATION SWITCH
This button is used only by qualified service persons
for maintenance purposes.