FVXS Operation Manual
Table Of Contents
- Features
- Contents
- Safety Considerations
- Names of Parts
- Preparation Before Operation
- AUTO · DRY · COOL · HEAT · FANOperation
- Adjusting the Airflow Rate
- Adjusting the Airflow Direction
- POWERFUL Operation
- ECONO Operation
- OUTDOOR UNIT QUIET Operation
- ON/OFF TIMER Operation
- WEEKLY TIMER Operation
- Note for Multi System
- Care and Cleaning
- FAQ
- Troubleshooting
- Quick Reference
30
English
Care
Titanium apatite photocatalytic air-purifying fi lter
1. Open the front panel and
pull out the air fi lter.
Page 28,29
2. Take off the titanium apatite
photocatalytic air-purifying
fi lters.
• Hold the recessed parts of the frame and unhook
the 4claws.
ClawClaw
3. Clean or replace the
titanium apatite
photocatalytic air-purifying
fi lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15minutes if very dirty.
• Do not remove the lter from the frame when
washing with water.
3-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the lter to remove water from it.
[Replacement]
Remove the fi lter from the fi lter
frame and prepare a new one.
• Do not throw away the lter frame. Reuse the lter
frame when replacing the titanium apatite
photocatalytic air-purifying lter.
• Dispose of the old lter as non- ammable waste.
4. Insert the titanium apatite
photocatalytic air-purifying
fi lters as they were.
• When attaching the lter, check that the lter is
properly set in the tabs.
5. Reattach the fi lters.
Page 29
6. Close the front panel slowly.
Page 28
NOTE
• Operation with dirty lters:
− cannot deodorize the air,
− cannot clean the air,
− results in poor heating or cooling,
− may cause odor.
• Dispose of old lters as non- ammable waste.
• To order a titanium apatite photocatalytic air-purifying lter, contact
the dealer where you bought the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying lter (without frame) 1set
Part No. KAF968B42
01_EN_3P379751-5C.indd 30 11/9/2015 13:35:49