5MXS48TVJU Installation Manual
Table Of Contents
- Safety Considerations
- Precautions for Selecting a Location
- Precautions on Installation
- Outdoor Unit Installation Diagram
- Installation Space Requirements
- Selecting a Location for Installation ofthe Indoor Units
- Connections (connection port)
- How to Use Reducers
- Outdoor Unit Installation
- Priority Room Setting
- Night Quiet Mode setting
- COOL/HEAT mode lock [S15]
- Pump Down Operation
- Trial Operation and Testing
5. Pressure test and evacuating system
• Make sure that air or any matter other than refrigerant (R410A) does not get into the refrigeration cycle.
• If refrigerant gas leaks should occur, ventilate the room as soon and as much as possible.
• R410A, as well as other refrigerants, should always be recovered and never be released directly into the environment.
pump or the unit.
this may result in refrigerant leakage.
• When piping work is complete, it is necessary to perform a pressure test
and evacuate system with a vacuum pump.
• If using additional refrigerant, perform air purging from the refrigerant
pipes and indoor unit using a vacuum pump, then charge additional
• All refrigerant pipe joints should be tightened with a torque wrench to the
1) Pressurize the liquid pipe and gas pipe from the service ports of each stop valve to 550psi (3.8MPa) (do not pressurize
more than 550psi (3.8MPa)) for 1 hour minimum, 24 hours recommended. If there is a pressure drop, check for leaks,
make repairs and perform the pressure test again.
2) Connect the gauge manifold’s charging hose to the gas stop valve’s service port.
3) Fully open the low-pressure valve (Lo) on the gauge manifold and fully close the high-pressure valve (Hi).
(High-pressure valve will require no further operation.)
5) Close the low-pressure valve (Lo) on the gauge manifold and stop vacuum pump.
(Maintain this condition for 4-5 minutes to make sure that the compound pressure gauge pointer does not swing back.)*
6) Remove the valve caps from the liquid stop value and gas stop valve.
Close it after 5 seconds, and check for gas leakage.
After the check is complete, wipe all soapy water off.
8) Disconnect the charging hoses from the service port for the gas stop valve, then fully open the liquid and gas stop valves.
(Do not attempt to turn the valve rods further than they can go.)
Refer to “4. Refrigerant piping” on page 9 for details.
If the compound pressure gauge pointer swings back, the refrigerant may have water content or there may be a loose
Check all pipe joints and retighten nuts as needed, then repeat steps 3) through 5).
01_EN_3P537039-1.indd 10 9/12/2018 7:37:44 PM