CTXS07LVJU Owners Manual

33
Care and Cleaning
Take off the titanium apatite 1.
photocatalytic air-purifying
fi lter.
Open the front panel and pull out the air fi lters.•
Hold the recessed parts of the frame and unhook •
the 4 claws.
Claw
Clean or replace the titanium 2.
apatite photocatalytic air-
purifying fi lter.
[Maintenance]
Vacuum dust, and soak in lukewarm 2-1
water or water for about 10 to
15 minutes if dirt is heavy.
Do not remove the fi lter from frame when washing •
with water.
After washing, shake off remaining 2-2
water and dry in the shade.
Since the material is made out of polyester, do not •
wring out the fi lter when removing water from it.
[Replacement]
Remove the tabs on the fi lter
frame and replace with a new
fi lter.
Do not throw away the fi lter frame. Reuse the fi lter •
frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
Dispose of the old fi lter as non-fl ammable waste.•
Set the fi lters as they were 3.
and close the front panel.
Press the front panel at both sides and the central •
area.
NOTE
Operation with dirty fi lters:•
cannot deodorize the air, –
cannot clean the air, –
results in poor heating or cooling, –
may cause odor. –
Dispose of old fi lters as non-fl ammable waste. •
To order titanium apatite photocatalytic air-purifying •
fi lter contact to the service shop there you purchased
the air conditioner.
Item
Titanium apatite photocatalytic
air-purifying fi lter (without frame) 1 set
Part No. KAF970A46
Titanium apatite photocatalytic air-purifying fi lter 
01_EN_3P297290-1.indd 3301_EN_3P297290-1.indd 33 10/21/2011 6:28:56 PM10/21/2011 6:28:56 PM