User manual

©2012DaikinACSlide28
PUBLIC CONFIDENTIAL
DRAFT
ConfiguringtheDaikinENVi Thermostat– ListofAlerts
Below is a complete list of alerts. Depending on your configuration, some of these may
not apply.
 Low Temp Alert: Temperature in the home is too low.
 High Temp Alert: Temperature in the home is too high.
 Heat Not Responding : The system has failed to heat the home.
 Cool Not Responding: The system has failed to cool the home.
 System Service: HVAC system due for regular maintenance.
 Auxiliary Heat Run Time: Auxiliary heat source is running too often.
 Auxiliary Outdoor Temperature: Your auxiliary heat has been called to run when the
outdoor temperature exceeds the programmed set point.
 System error, service required: System error occurred. If the Inddor Units’s status
LED is blinking after the error has been corrected, select Settings ▶ Installation
Settings ▶ Force System Off to reset the latched error status and turn off the blinking
LED.
•Lost Communication: Communication with the Indoor Unit has been lost. Check the
wiring connections between the DPCA, ENVi thermostat and Indoor Unit. The green LED
on DPCA should be on and solid.
•Upon initial power up of the system communication, this alert may be generated. Wait up
10 minutes for system to initialized before troubleshooting. The alert will be removed
automatically once communication has been established.