Installation manual

Step 3. Install the Daikin ENVi Thermostat
The ideal location for the thermostat is approximately 5 ft (1.5 m)
above oor level in the main living area.
Do not install the thermostat:
Close to sources of heat such as incandescent lights
Near supply heating/cooling sources
In direct sunlight
On exterior, non-insulated or poorly insulated walls
In the kitchen or other areas of potentially high heat and/or
humidity
In an area that could restrict air ow
To install the thermostat:
1. If necessary, remove the previous thermostat.
1. Gently separate the backplate from the Daikin ENVi
thermostat.
2. Place the thermostat backplate on the wall. Make sure that
any existing wires can be inserted through the opening for
the wiring.
If the backplate does not adequately cover the area where
the previous thermostat was installed, attach the trim plate
to the back of the backplate to increase its coverage.
3. Using the backplate as a template, mark the location of the
mounting holes on the wall as shown.
10