Installation manual

Reset Contractor Info Resets any
information about the Contractor who
installed the Daikin ENVi thermostat.
Rebooting the Daikin ENVi
thermostat
You can reboot the Daikin ENVi thermostat by
pressing the physical hardware reset button,
located through an opening in the bottom left
corner of the Daikin ENVi thermostat. Rebooting
will not alter programming or conguration
options.
Sensors
By default, the Daikin ENVi thermostat’s Internal
Sensor is used for an accurate indication of the
room temperature (recommended setting).
The Indoor Unit is also equipped with a room
temperature sensor which you can use instead.
You can also enable both sensors to provide
an average sensing temperature. However, the
Indoor Unit sensor and averaging methods are
not recommended because the Indoor Unit
sensor, especially wall-mounted models, can be
aected by certain operations such as starting
up and defrosting in a short time which may
cause improper control of the indoor unit by the
ENVi Thermostat.
Reset button
To select the
temperature sensor:
From the Home screen,
press MENU.
Select Sensors ▶
Congure.
Enable or disable each
sensor by selecting
Internal Sensor or Indoor
Unit and then selecting
Yes or No.
23