Service manual

General Outline: Indoor Units ESIE04-01

1–32 Part 1 – System Outline

2.12 FHQ125BUV1B

Outlook and

dimensions

The illustration below shows the outlook and the dimensions of the unit (mm).

Position slit hole for taking out in piping back

or more

(Service Space)

Brand name plate

(Note 2)

Drain pipe

connection

(For left piping)

The front

Floor side

Obstacle

(Required space)

or more

For height installation

or more

(Required space)

(View from the front)

(Hanging position)

Hanging bolt

(Required space)

Position: Hole of wall for taking out in piping back

(View from the front)

or more

(Service Space)

NOTES:

1. Location of unit’s Name plate: Bottom of fan

housing inside the suction grill.

2. In case of using wireless remote controller, this

position will be a signal receiver. Refer to the

drawing of wireless remote controller in detail.

3. The remote control code is the standard

<about 3m outside the machine> attached.

(0.5mm² x 2wicks x O.D. ø 5.4)

(It is not attached to VRV.)

From the floor side

RZQ - Final.book Page 32 Monday, September 20, 2004 11:24 AM