Service Manual

SiUS181631EA BRC082A41W, BRC082A42W(S) (Wireless Remote Controller Kit)
Remote Controller 171
1
2
3
DISPLAY (SET TEMPERATURE)
This display shows the set temperature.
4
5
DISPLAY (SWING FLAP)
6
DISPLAY (FAN SPEED)
The display shows the set fan speed.
7
8
ON/OFF BUTTON
9
FAN SPEED CONTROL BUTTON
10
TEMPERATURE SETTING BUTTON
DISPLAY (SIGNAL TRANSMISSION)
This lights up when a signal is being
transmitted.
DISPLAY , , , ,
(OPERATION MODE)
This display shows the current OPERATION
MODE.
DISPLAY (PROGRAMMED
TIME)
This display shows PROGRAMMED TIME
of the system start or stop.
DISPLAY /TEST (INSPECTION/TEST
OPERATION)
When the INSPECTION/TEST OPERATION
button is pressed, the display shows the
system mode is in.
Press the button and the system will start.
Press the button again and the system will
stop.
Press this button to select the fan speed,
LOW, MEDIUM or HIGH, of your choice.
Use this button for setting temperature.
11
TIMER MODE START/STOP BUTTON
12
TIMER RESERVE/CANCEL BUTTON
13
AIRFLOW DIRECTION ADJUST BUTTON
14
OPERATION MODE SELECTOR BUTTON
15 FILTER SIGN RESET BUTTON
16
INSPECTION/TEST OPERATION BUTTON
17
EMERGENCY OPERATION SWITCH
18
RECEIVER
19
OPERATION LAMP (Red)
20
TIMER LAMP (Green)
This lamp stays lit while the timer is set.
21
22
DEFROST LAMP (Orange)
Press this button to select OPERATION MODE.
This button is used only by qualified service
persons for maintenance purposes.
This switch is readily used if the remote
controller does not work.
This receives the signals from the remote
controller.
This lamp stays lit while the air conditioner
runs. It blinks when the unit is in trouble.
AIR FILTER CLEANING TIME INDICATOR
LAMP (Red)
Lights up when it is time to clean the air
filter.
Lights up when the defrosting operation has
started.