Specifications

SiBE28-805 Troubleshooting (OP: Unified ON/OFF Controller)
Troubleshooting 227
Check for causes of rise in high pressure
Referring to the Fault Tree Analysis (FTA) shown below, probe the faulty points.
CHECK 3
Short circuit
Rise in high
pressure
Local
pressure
rise
High pipe
resistance
Stop valve closed
Bent or crashed pipe
Clogging of foreign
particles
← Check to be sure the stop valve is open.
← Conduct visual checks for pipe conditions.
← Is there any temperature difference caused before
and after the filter or branch pipe.
[In cooling]
If the outdoor unit electronic
expansion valve is throttled:
(See *1.)
Faulty outdoor
unit motorized
valve
Faulty valve coil
Faulty valve body
← Are the coil resistance and insulation normal?
A temperature difference in excess of 10°C
between the inlet and the outlet is deemed to be abnormal.
Faulty
control
Faulty high pressure sensor
Faulty control PC board
← Are the electrical characteristics normal?
← Is the pressure value checked with the Service Checker
corresponding to the measurement of the pressure sensor?
←Are the coil resistance and insulation
normal?
Faulty high
pressure
control
Faulty indoor
unit motorized
valve
Faulty valve coil
Faulty valve body
[In heating]
If the indoor unit electronic
expansion valve excessively
throttled:
(See *2.)
Faulty
control
Faulty high pressure sensor
Faulty indoor unit
liquid pipe thermistor
Faulty control PC board
← Are the electrical characteristics normal?
← In the connector properly connected?
Are the thermistor resistance characteristics normal?
← Is the pressure value checked with the Service
Checker corresponding to the measurement of the
pressure sensor?
[In cooling]
High suction
air
temperature
of the
condenser
[In heating]
High suction air
temperature
of outdoor unit
Short circuit
High ambient temperature
← Is the suction air temperature not more than
43°C?
← Is the outdoor temperature not more than 43°C?
High suction
air temperature
of indoor unit
High ambient temperature
← Is the suction air temperature not more than 27°C?
← Is the indoor temperature not more than 27°C?
Faulty suction air thermistor of indoor unit
High suction air temperature of outdoor unit
Faulty outdoor temperature thermistor of outdoor unit
← Is the connector properly connected?
Are the thermistor resistance characteristics normal?
← Is the outdoor temperature not more than 16°CWB?
← Is the connector properly connected?
Are the thermistor resistance characteristics normal?
Degradation
in condensing
capacity
Dirty condenser
Mixing of non-condensable gas
←Is the heat exchanger clogged? (In cooling)
←Is air or else mixed in the refrigerant system?
Decreased
fan airflow
rate
Decreased
fan
output
Faulty fan
motor
←Can the fan motor be rotated with hands?
Are the motor coil resistance and
insulation normal?
←If a spare PC board is mounted, is the
capacity setting properly made?
Faulty control
PC board
(Including
capacity setting)
High air
passage
resistance
Dirty filter
←Is the air filter clogged?
Obstacle
←Is there any obstacle in the air passage?
Excessive refrigerant charging
Improper model selection
[In heating]
←Refer to page 165.
←Is the indoor unit too small compared to
the large-sized outdoor unit?
*1:
In cooling, it is normal if the outdoor unit electronic expansion valve (EV1) is fully open.
*2: In heating, the indoor unit electronic expansion valve is used for “subcooled degree control”.
(For details, refer to “Electronic Expansion Valve Control” on page 59.)
SDK04009