Operation Manual

10
EnglishEnglish
Read Before Operation
Preparation Before Operation
To insert the batteries
1. Remove the back cover by sliding and then
slightly lifting it�
2. Insert 2 dry batteries AAA�LR03 (alkaline)�
3. Replace the back cover�
To x the remote controller holder to a wall
1. Choose a place where the signals reach the unit�
2. Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the holder�
3. Hang the remote controller on the remote
controller holder�
Fahrenheit/Celsius display switch
Press and (TIMER button)
simultaneously for about 5 seconds�
•ThetemperaturewillbedisplayedinCelsiuswhenitispresentlydisplayedin
Fahrenheit,andviceversa.
•Theswitchoperationisonlypossiblewhenthetemperatureisbeingdisplayed.
Turn on the circuit breaker
•Afterthepoweristurnedon,theapoftheindoorunitopensandclosesoncetosetthe
referenceposition.
Position and
correctly!
2
3
1
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
•Whenreplacingthebatteries,usebatteriesofthesametype,andreplacebotholdbatteriestogether.
•Thebatterieswilllastforabout1year.Iftheremotecontrollerdisplaybeginstofadeandthepossibletransmissionrangebecomesshorterwithin
ayear,however,replacebothbatterieswithnew,sizeAAA.LR03(alkaline).
•Thebatteriessuppliedwiththeremotecontrollerareforinitialoperation.Thebatteriesmayrunoutinlessthan1year.
Note on remote controller
•Donotdroptheremotecontroller.Donotgetitwet.
Fahrenheit/Celsius display change function of remote controller
•ThesettemperaturemayincreasewhenthedisplayischangedtoCelsiusfromFahrenheit,becauseafractionof0.5°Cisroundedup.
• Example:Asettemperatureof65°F(equivalentto18.5°C)willbeconvertedinto19°C.
WhenthedisplayischangedtoFahrenheitagain,thesettemperaturewillbeconvertedinto66°F(equivalentto19°C)insteadoftheoriginal
settemperature(65°F)butasettemperatureof66°F(equivalentto19°C)willbeconvertedinto19°Cwithnotemperaturechange.
• AreceptionsoundwillgooffforthetransmissionofsettemperaturetotheindoorunitatthetimeofsettingtheFahrenheit/Celsiusdisplaychangefunction.
01_EN_3P379751-2A.indd 10 11/12/2014 6:18:35 PM