Operation Manual

21
Care
 Titanium apatite photocatalytic air-purifying  lter
1. Open the front panel and
pull out the air  lters.
Page 20
2. Take off the titanium apatite
photocatalytic air-purifying
 lters.
•Removetheltersfromthetabs.
3. Clean or replace the
titanium apatite
photocatalytic air-purifying
 lters.
[Cleaning]
3-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15minutes if very dirty.
3-2 After washing, shake off remaining
water and let them dry in the shade�
•Donotwringouttheltertoremovewaterfromit.
[Replacement]
Remove the  lter from the tabs
and prepare a new one�
•Disposeoftheoldlterasnon-ammablewaste.
4. Insert the titanium apatite
photocatalytic air-purifying
 lters as they were.
•Whenattachingthelter,checkthatthelteris
properlysetinthetabs.
5. Reattach the  lters.
Page 20
6. Close the front panel slowly�
Page 20
NOTE
•Operationwithdirtylters:
−cannotdeodorizetheair,
−cannotcleantheair,
−resultsinpoorcooling,
−maycauseodor.
•Disposeofoldltersasnon-ammablewaste.
•Toorderatitaniumapatitephotocatalyticair-purifyinglter,contact
thedealerwhereyouboughttheairconditioner.
Item
Titaniumapatitephotocatalytic
air-purifyinglter1set
Part No� KAF970A46(withoutframe)
Care and Cleaning
FTK09NMVJU / FTK12NMVJU / FTKN09NMVJU / FTKN12NMVJU
01_EN_3P379751-2A.indd 21 11/12/2014 6:18:47 PM