Operation Manual

English
22
ON TIMER Operation
To use ON TIMER operation 
Check that the clock is correct.•
If not, set the clock to the present time.
Page 10
Press 1. .
“ • ” is displayed on the LCD.
“ • ” blinks.
“ • ” and day of the week disappear from the LCD.
Press 2. until the time setting reaches the
point you like.
Each pressing of either button increases or decreases the time setting by 10 minutes. •
Holding down either button changes the setting rapidly.
Press 3. again.
“ • ” and setting time are displayed on the LCD.
The multi-monitor lamp blinks twice.•
The TIMER lamp periodically lights orange.
Page 5
Display
To cancel ON TIMER operation 
Press .
“ • ” and setting time disappear from the LCD.
“ •
” and day of the week are displayed on the LCD.
To combine ON TIMER and OFF TIMER 
A sample setting for combining the 2 timers is shown below.•
(Example)
Present time: 23:00 (The unit operating)
OFF TIMER at 0:00
ON TIMER at 14:00
Combined
NOTE
In the following cases, set the timer again. 
After a circuit breaker has turned off.•
After a power failure.•
After replacing batteries in the remote controller.•
01_EN_3P357704-1.indd 2201_EN_3P357704-1.indd 22 12/17/2013 3:22:12 PM12/17/2013 3:22:12 PM