Operation Manual

English
32
CAUTION
Do not touch the aluminium fi ns by bare hand at the time of dismounting or mounting the fi lter.•
Pull out the air fi lters.1.
Open the upper front panel.•
Set the panel support plate between the ribs on •
the unit to fi x the upper front panel.
Push the fi lter tab at the center of each air fi lter a •
little upwards, then pull it down.
3) Pull down
2) Push
Filter tab
1) Pull
Panel support plate
Ribs
Back of the upper
front panel
Wash the air fi lters with 2.
water or clean them with
vacuum cleaner.
It is recommended to clean the air fi lters every •
2 weeks.
If the dust does not come off easily
Wash the air fi lters with neutral detergent thinned with •
lukewarm water, then dry them up in the shade.
Be sure to remove the titanium apatite photocatalytic •
air-purifying fi lter. Refer to “Titanium apatite
photocatalytic air-purifying fi lter” on the next page.
Set the fi lters as they were 3.
and close the upper front
panel.
Return the panel support plate to its previous •
position.
Lower the lower front panel to the original •
position.
Close the upper front panel slowly.•
Press the upper front panel at both sides.•
Air fi lter 
01_EN_3P357704-1.indd 3201_EN_3P357704-1.indd 32 12/17/2013 3:22:22 PM12/17/2013 3:22:22 PM