Operation Manual

33
Care and Cleaning
Take off the titanium 1.
apatite photocatalytic air-
purifying fi lter.
Open the upper front panel and pull out the air fi lters. •
Hold the recessed parts of the frame and unhook •
the 4 claws.
Claw
Clean or replace the titanium 2.
apatite photocatalytic air-
purifying fi lter.
[Maintenance]
Vacuum dusts, and soak in 2-1
lukewarm water or water for about
10 to 15 minutes if dirt is heavy.
Do not remove the fi lter from frame when •
washing with water.
After washing, shake off remaining 2-2
water and dry in the shade.
Since the material is made out of polyester, do not •
wring out the fi lter when removing water from it.
[Replacement]
Remove the fi lter from the fi lter
frame and attach a new one.
Do not throw away the fi lter frame. Reuse the •
fi lter frame when replacing the titanium apatite
photocatalytic air-purifying fi lter.
When attaching the fi lter, check that the fi lter is •
set in the tabs.
Tabs
Dispose of the old fi lter as non-fl ammable waste.•
Set the fi lters as they were and 3.
close the upper front panel.
Return the panel support plate to its previous position. •
Lower the lower front panel to the original position. •
Close the upper front panel slowly.•
Press the upper front panel at both sides.•
NOTE
Operation with dirty fi lters:•
cannot deodorise the air, –
cannot clean the air, –
results in poor heating or cooling, –
may cause odour. –
Dispose of old fi lters as non-fl ammable waste. •
To order titanium apatite photocatalytic air-purifying •
fi lter, contact the service shop where you bought the air
conditioner.
Item
Titanium apatite photocatalytic
air-purifying fi lter (without frame) 1 set
Part No. KAF970A46
Titanium apatite photocatalytic air-purifying fi lter 
01_EN_3P357704-1.indd 3301_EN_3P357704-1.indd 33 12/17/2013 3:22:25 PM12/17/2013 3:22:25 PM