Operation Manual

35
■
Check the units
■
Check that the base, stand and other ttings of the outdoor unit are not decayed or corroded.
■
Check that nothing blocks the air inlets and the outlets of the indoor unit and the outdoor unit.
■
Check that the drain comes smoothly out of the drain hose during COOL or DRY operation.
• If no drain water is seen, water may be leaking from the indoor unit. Stop operation and consult the service shop if this is the
case.
■
Before a long idle period
1. Operate the FAN only for several hours on a ne day to dry
out the inside.
• Press and select “ ” operation.
• Press
and start the operation.
2. After operation stops, turn off the breaker for the room air
conditioner.
3. Clean the air lters and set them again.
4. Take out batteries from the remote controller.
• When a multi outdoor unit is connected, make sure the HEAT operation is not used at the other room before you use
the FAN operation.
Page 29
■
We recommend periodical maintenance
• In certain operating conditions, the inside of the air conditioner may get foul after several seasons of use, resulting in poor
performance. It is recommended to have periodical maintenance by a specialist aside from regular cleaning by the user.
• For specialist maintenance, contact the service shop where you bought the air conditioner.
• The maintenance cost must be borne by the user.
■
Important information regarding the refrigerant used
• This product contains uorinated greenhouse gases covered by the Kyoto Protocol.
Refrigerant type:R410A
GWP
(1)
value:1975
(1) GWP = global warming potential
• Periodical inspections for refrigerant leaks may be required depending on European or local legislation. Please contact your
local dealer for more information.
Care and Cleaning