Service manual

Operation Manual SiBE811120
18 Photocatalytic Air Purifier L-Series
11
Preparation before Operation
Installation of the unit
Installed on a table or the floor
100cm from ceiling
50cm from wall
Airflow
50cm from wall
10cm from wall
Hints for smart installation
• To remove house dust, it is effective to install the unit at a lower position in the room. To
remove cigarette smoke, it is effective to install the unit in a higher part of the room.
• If you install the air purifier opposite the air conditioner, the circulation effect is enhanced.
The unit controls unevenness in the room temperature while cleaning the air during
heating or cooling operation.
• Keep TVs, radios and stereos 2m or more away from the unit.
(The effects of the power circuit inside the unit and cable may cause a distorted TV
picture or noise.)
Keep cordless phones or atomic radio clocks away from this unit also.
Airflow
Do not use the unit in the following places.
• Do not use the unit in a location exposed to direct sunlight.
(The response of the main unit to the signal from the remote controller may be weakened and the colour may change.)
• Do not use the unit in locations of high temperature.
(Heat may discolour and deform the unit.)
CAUTION
• The wall where the air purifier is set may get dirty depending on
the type of wall and environment, even if you follow the
specified dimensions of left. In such cases, move the unit a safe
distance away from the wall.
• If the air purifier is used for a long time at the same location,
the bottom of the unit and floor may become dirty due to the
suction air flow from the bottom of the unit. Periodic cleaning is
recommended.
ATTENTION
• The air is blown slightly to the right, but nothing is wrong with the
unit.
• Select a location which allows the air to reach the entire room.
• Place the air purifier on a flat area where it is stable. If the floor is
uneven, the unit may vibrate excessively.