Service manual

SiBE811120 Operation Manual
Photocatalytic Air Purifier L-Series 23
16
5
Pleated filter
6
Deodorising catalyst unit
7
Pleated filter
Air inlet for odour sensor
If the filter lamp lights up or blinks
Replace
If it gets dirty
Vacuum cleaner
Can not be rinsed in water
If it is clogged
Vacuum cleaner
Wipe
NOTE
Replacement XPage 21.
Rear of front panel
Bottom holeProjections
WARNING
Main unit or air inlet
for sensor
Air inlet for
air quality sensor
Do not rub the
front surface.
Do not rinse
with water.
Deodorising
catalyst unit
Face the white
side to the front.
• If the main unit or the air inlet for the air
quality / odour sensor is clogged with dust,
use a vacuum cleaner to remove the dust.
• For the main unit, wipe off the dirt with a
cloth slightly moistened with water.
• Use a vacuum cleaner to remove the dust.
• If the deodorising catalyst unit frame
becomes dirty, wipe off the dirt with a cloth
slightly moistened with water. In the case of
heavy dirt, wipe it off with a cloth moistened
with neutral detergent.
• Do not wash with water. (If the unit is
washed with water, it will be deformed and
become unusable.)
• Be careful not to scratch the surface of the front panel or damage the projections on the rear of it after it is removed.
The projections on the rear work as a safety switch that shuts power off when the front panel is opened.
If they are damaged, operation can not start.
Be careful not to damage
these projections.
• Do not touch the inside of the hole at the bottom of the unit.
(Electric shock may occur.)
• Consult your dealer if the unit is damaged and does not
operate.