Service manual

Operation Manual SiBE811120
26 Photocatalytic Air Purifier L-Series
4.8 Cleaning of UNIT1 and UNIT2
UNIT1
(Plasma ioniser)
UNIT2
(Streamer unit)
19
Cleaning of UNIT1 and UNIT2
Soak, drain and dry Wipe
XPage 17.
Procedure
UNIT1
Remove the parts.
XPage 17, 18.
XPage 18.
Wipe
Rub
Rinse in running water and drain.
Attach the parts.
XPage 17, 18. XPage 18.
1) Ionising frame (Remove dirt after soaking but before drying.)
Soak in lukewarm water or water.
(About 1 hour)
2) Ionised wire (rear)
1) Ionising frame
4) Streamer unit
1) Ionising frame 2) Ionised wire 3) Opposing pole plates
Use a vacuum cleaner to remove the
dust.
Remove dirt with a piece of cloth, soft
brush, etc.
Wear rubber
gloves.
Dry in a well-ventilated, shaded
place. (About 1 day)
• Remove dirt from plastic parts with a soft piece of cloth.
• Use a cotton swab, etc. to wipe away dirt in recesses and places where fingers do not fit.
• Do not leave any lint from cleaning cloths behind. Lint may lead to malfunctions.
* Remove dirt from recesses
with a cotton swab, etc.
Wear rubber
gloves.
Wear rubber
gloves.
Wear rubber
gloves.
For details, see 1) and
2) below.
3) Opposing pole
plates
Time for
cleaning
Cleaning
method
UNIT1:
If the “UNIT1” lamp lights
UNIT2:
Once every 3 months or if
the “UNIT2” lamp lights
If marking is a concern, clean the unit even if the “UNIT1” and “UNIT2”
lamps do not light.
For details on removing and attaching each part,
see .