Operation Manual

33
Care and Cleaning
1. Take off the titanium apatite
photocatalytic air-purifying
 lter.
• Open the front panel and pull out the air  lters.
• Hold the recessed parts of the frame and unhook
the 4claws.
Claw
2. Clean or replace the titanium
apatite photocatalytic air-
purifying  lter.
[Maintenance]
2-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15minutes if dirt is heavy.
• Do not remove the  lter from frame when washing
with water.
2-2 After washing, shake off remaining
water and dry in the shade.
• Since the material is made out of polyester, do not
wring out the  lter when removing water from it.
[Replacement]
Remove the tabs on the  lter
frame and replace with a new
 lter.
• Do not throw away the  lter frame. Reuse the  lter
frame when replacing the titanium apatite
photocatalytic air-purifying  lter.
• Dispose of the old  lter as non- ammable waste.
3. Set the  lters as they were
and close the front panel.
• Press the front panel at both sides and the central
area.
NOTE
• Operation with dirty  lters:
– cannot deodorize the air,
– cannot clean the air,
– results in poor heating or cooling,
– may cause odor.
• Dispose of old  lters as non- ammable waste.
• To order a titanium apatite photocatalytic air-purifying
 lter, contact the dealer where you bought the air
conditioner.
Item
Titanium apatite photocatalytic
air-purifying  lter (without frame) 1set
Part No. KAF970A46
 Titanium apatite photocatalytic air-purifying  lter
01_EN_3P297290-1C.indd 33 12/8/2015 13:27:42