Specifications

EDUS04-740 Optional Accessories
Room Air Conditioners D-Series 121
13.2.3 KPW937A4
3P157704-2A
b)
Checking the parts
Installation of Louver
CAUTION
Louver
1piece1piece
Shape
Quantity
Selection of Installation Location
Check the following parts
a)
I Before Installation
I Installation Procedure
Use when installing in a location that meets the following conditions.
When installing near the border to a neighbor's house
If exhaust blows directly on passers-by because outdoor unit is installed facing a road.
Changing the fan direction of the outdoor unit to prevent it blowing directly on shrubbery, etc.
Installation is possible in the four directions:
upward, downward, rightward, and leftward.
The installation screws are attached to the louver.
First temporarily attach the louver with 4 screws,
then check that the angle is correct, and finally
tighten the screws fully.
1.Install so that a short circuit is prevented.
2.For the use in snowy regions, avoid installation
with the air o
utlet facing upward. Install so that
the air outlet faces leftward, rightward, or down-
ward.
Snow accumulates in the air outlet of the outdoor
unit, causing malfunction of the main body of the
outdoor unit.
3.Be advised that if the fan direction is up,
dead leaves and other foreign matter
easily accumulates in the exhaust vent.
Name
With 4 screws
Installation manual
Prepared hole
pitch 17 inches
Fan partition
Prepared hole
pitch 17 inches
Fan partition
Part A
(see figure below)
The prepared hole is in between the grating
of the grille. Part A (prepared hole) cross
section (the shape of either a or b)
Grille grating
Prepared hole Prepared hole
Grille grating
4P104499-1A