Instructions / Assembly
SMP‐LED‐8‐Installationinstruc t ions
Important information
Caution
This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product
and the hazards involved. We recommend you use a licenced electrician.
This low voltage accent light is suitable for mounting inside cabinet.
Use only 24V DC LED driver supplied by Dainolite to max 96W for Class II installations. Do not use the full capacity of driver. We recommend 80%
capacity usage. Following these guidelines will prolong the useful life of driver and LED light.
To reduce the risk of fire, electric shock, or injury to persons, follow these guidelines:
a) Use only insulated staples or plastic ties to secure cords.
b) Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to wall or permanently attached to the wall.
c) This product is not intended for recessed installation in ceilings or soffits.
d) The National Electrical Code (NEC) does not permit most LVT cords to be concealed where damage to insulation may go unnoticed. To
prevent fire danger, do not run cord behind walls, ceilings, soffits or cabinets where it may be inaccessible for examination. Cords should be
examined periodically and immediately replaced when any damage is noted.
Dainolite Ltd. offers a special cord model CMG18/16T that can be used to go behind walls and ceilings.
This cord meets NEC / UL / CSA standards.
e) This product may represent a possible shock or fire hazard if improperly installed. Install in accordance with these instructions, current
electrical codes and / or the current National Electric Code (NEC). Disconnect power prior to installation.
f) This product has no serviceable parts. Do not attempt to open.
g) Do not use luminaire with a damaged lens, body or cable.
Recessed mounting installation
1) Drill 73mm (2⅞”) hole for accent light
2) Feed the wire with male connector through mounting hole and connect to female connector of wire harness (DLST42 four connector wire harness –
purchased separately).
3) Do not cut off connectors and use marrets. This action will void the warranty. Use multiple (4) connector harness DLST42 (purchased separately) or
single unit harness DLST42-5 (purchased separately).
4) Push light into hole. The spring clips will hold the light in place firmly!
5) Repeat steps 1 through 4 for the remaining lights to be installed. Then follow the steps “Power up your lights”
6) Maximum number of lights on one Class II installation is 10 (using 96 Watt Class II driver)
Unique features:
- SMP-LED-8 comes with 25° lens. This focuses the light allowing greater penetration in tall cabinets.
- Head is adjustable to 25°
- For those applications requiring more beam spread, Dainolite offers a 40°replacement lens - LENS-40 (purchased separately).
- This product uses high quality Osram LED chips ensuring longer life and colour consistency!
Versionfrançaisedecesinstructionsdisponibles
surlesiteInternet:www.dainolite.ca
SAVETHESEINSTRUCTIONS
LR1331
8W‐LED
OSRAM
3000K–CRI80+