Operation Manual

MAINTENANCE

WARNING

Before you clean the air conditioner, be sure to

disconnect the power supply plug.

If you do not plan to use the unit for at least 1 month.

(1) Operate the fan for about half a day to dry the inside

of the unit.

(2) Stop the air conditioner and disconnect power.

(3) Remove the batteries from the remote controller.

Before you clean the air conditioner be sure to disconnect

the power supply plug.

1. Pull up from two ends of panel. Open the panel and

lift the panel up to an angle where it remains fixed.

Do not lift the panel any further when it stops with a

clicking sound.

2. Take hold of the left and right handles of the air filter

and lift it up slightly to take it out from the filter holder.

Use a dry cloth to wipe the indoor unit and remote

controller.

A cloth dampened with cold water may be used on

the indoor unit if it is very dirty.

Never use a damp cloth on the remote controller.

Do not use a chemically-treated duster for wiping

or leave such materials on the unit for long. It may

damage or fade the surface of the unit.

Do not use benzine, thinner, polishing powder, or

similar solvents for cleaning.

These may cause the plastic surface to crack or

deform.

CAUTIONS

Cleaning the indoor unit and the remote

controller

Check that the wiring is not broken off or is not

connected.

Check that the air filter is installed.

Check that the outdoor unit air outlet or inlet is not

blocked.

CAUTIONS

Checks before operation

Cleaning the air filter

Thinner

Use a dry cloth to wipe

Select fan only mode

Air Filter Handle