Manual

370 S 370 S L 370 PP 370 PP L
36
Vise Gib Adjustment 370 PP / S check as needed
Way Oiler 370 PP / S 2 pumps check / add
DRO Magnetic Strip 370 PP wipe / clean
DRO Reader Adjustment 370 PP check / set if needed
Lube Types Head Feed Cylinder.-DTE 24
Hydraulic Oil
Spindle Grease -Hi Temp. Way Oiler-Light Weight Way Oil
Air Oiler - Tool Oil Clean DRO Strip-Clean Dry Rag
TROUBLSHOOTING GUIDE
FERROUS & NON-FERROUS HEAD
PROBLEM THINGS TO CHECK SOLUTION
Blade chatters while cutting Blade pitch, gullets are packed Replace blade, regrind, clean gullets
Part moves while cutting Check how parts are clamped, rear vise Reclamp or fixture as needed
Par has hanging burr Part distorted while clamped, anti burr
vise
Adjust anti burr arm or outboard vise
Part has burr on exit of cut Lack of support on short pieces Add solid wear plate to support part
Rough or scored finish Blade dull, incorrect blade, tooth
missing
Replace blade, Reclamp part
Blade Breaks Backlash, dull blade, part moved in
vise
Replace blade, Reclamp part
Motor/Gear box noise Low oil, excessive backlash Add oil, adjust backlash
Head is jerky Binding components, air in system If oil is full, bleed head cylinder
Motor hums or runs slow Check Power source fuses, hood
interlock
Replace fuses, close hood
Motor runs backwards Leads on incoming power are incorrect Have qualified electrician make a
change
No power to the machine Check power source fuses, hood
interlock
Replace fuses, close hood
Vises do not operate or are slow Incoming air pressure, regulator
pressure
Increase air pressure, set higher
Head stops down feeding Lack of air, flow control valve
adjustment
Increase air pressure, adjust valve
Head returns slow Gib strip adjustment, air return valve
closed
Adjust gib, open-air return valve more
Tolerances slipping Feeder too fast, blade, overfeeding Slow feeder, adjust blade thickness
Unsquare cutting Wrong, dull blade thickness
adjustment
Slow feeder, adjust blade thickness
Will not feed material (370PP) Multiple stroke counter, vise position
reversed
Multiple stroke set at 0, switch forward
Motor runs hot Incoming voltage too high Power should be +/- 10%
Head crashes down Low or no oil in head feed cylinder
leakage
Add oil to cylinder as outlined repair
leak
Machine stops (370PP) Blade protection stops operation Correct problem and reset calibration
unit
Machine will not restart Security locked out, piece counter not
cleared
Turn key to on position, clear counter
Machine will not start E-stop activated, out of stock Reset E-stop, check feed vise clearance
* Parts may come off hot, this is normal with non-ferrous cutting.