Owner's manual

12/10/07 Model LE13A Text 12

4. AUTO-MANUAL SELECTOR

For Continuous cutting, turn this selector to

To individually operate each function, turn this selector to the hand picture

(MANUAL).

5. QUICK APPROACH BUTTON

When this button is pressed the head will move in the downward position until the

quick approach arm touches the material.

6. RAISE BUTTON

When this button is pressed the blade motor stops and the saw head moves in the

upward position. When the button is released the head will stop moving.

7. VISE CLAMP BUTTON

When this button is pressed and held, one vise will open and the other vise will

8. VISE CLAMP SELECTION

When this selector is turned to the left (see picture to the right) with the auto-

manual selector (4) turned to MANUAL the front vise opens and the rear vise

closes; when the selector is turned to the picture (on the lower left of this

paragraph) the rear vise opens and the front vise closes.

NOTE: On the manual operation, if this selector is

Not turned to the “Rear vice open” the saw blade motor will not operate even if the

drive button (3) is depressed.

9 & 10 REAR VISE FORWARD AND BACKWARD BUTTONS

When the forward button (9) is depressed with the auto-manual selector turned to

“MANUAL” the rear vise moves forward; when the backward button (10) is

depressed, the rear vise moves backward. The rear vise stops moving when the

button is released.

11. CUTTING FLUID PUMP SWITCH

When this switch is set at “|” the cutting fluid pump operates and the cutting fluid will

be on even though the saw blade motor is not in operation. Use this switch when

removing saw chips with the cutting fluid (without the blade operation).

12. CUTTING PIECE COUNTER

This counter is used to press the number of cuts required on the automatic

operation. When the counter reaches the preset number, the machine automatically

stops. To activate the counter, set the counter ON/OFF witch at “| “

(AUTO).

Front vise

opens

Rear vise

opens