Manual

Dake Tube Bender Manually operated 08212009 1

724 Robbins Road

Grand Haven, Michigan 49417

616-842-7110 Phone 800-937-3253

616-842-0859 Fax 800-846-3253

Web: www.dakecorp.com

E-mail: customerservice@dakecorp.com

technicalsupport@dakecorp.com

Dake Tube Bender Manual

Instructions and part list

Manually operated

PAGE 1
724 Robbins Road Grand Haven, Michigan 49417 616-842-7110 Phone 800-937-3253 616-842-0859 Fax 800-846-3253 Web: www.dakecorp.com E-mail: customerservice@dakecorp.com technicalsupport@dakecorp.
PAGE 2
Thank you for buying Dake!!!! We hope you enjoy many years of using your New Dake Tube Bender. If after reading this manual you still have any questions please give us a call, e-mail or stop by for a factory tour. www.dakecorp.com 724 Robbins Road Grand Haven, MI 49417 Phone: 616-842-7110 800-937-3253 CAUTION!!! Read and understand all warnings, cautions, attentions and instructions before operating this equipment. CAUTION general When working always pay attention and be alert. Be careful.
PAGE 3
Before operating this equipment review and understand the safety label below that is on the tube bender. The picture above shows where this safety label is located on the machine. Unpacking your New Dake Tube Bender Make sure you have all the parts supplied to assembly your Tube Bender.
PAGE 4
Assembling your Dake Tube Bender 1. Remove your die pin and insert your red handle and the die in the slot of your die body, line up the holes and reinstall the die pin. 2. DO NOT tighten the die pin. The pin head should just touch the gray die body. If it is tightened it will lock up the parts and bend the die body. 3. Take the piece holder and put it in one of the other holes as shown below. This piece will be in different locations depending on the diameter of the material. 4.