Manual

ZIP 30 - MULZIP 30 - MUL

ZIP 30 - MUL

TI MODETI MODE

TI MODE

This set is associated with very fine teeth and it is mainly used

for the cutting of pipes and thin section bars (from 1 to 3 mm).

ALTERNATE SET (IN GROUPS): Groups of cutting teeth right

and left, alternated by a straight tooth.

This set is associated with very fine teeth and it is used for

extremely thin materials (less than 1 mm).

ALTERNATE SET (INDIVIDUAL TEETH): Cutting teeth right

and left.

This set is used for the cutting of nonferrous soft materials,

plastics and wood.

Set

Saw teeth bent out of the plane of the saw body, resulting in a

wide cut in the workpiece.

REGULAR OR RAKER SET: Cutting teeth right and left, alter-

nated by a straight tooth.

Of general use for materials with dimensions superior to 5 mm.

Used for the cutting of steel, castings and hard nonferrous ma-

terials.

WAVY SET: Set in smooth waves.

9.7.1 - RECOMMENDED CUTTING PARAMETERS

STEEL CUTTING SPEED LUBRICATION

CONSTRUCTION 60/80 EMULSIFIABLE OIL

CEMENTATION 40/50 EMULSIFIABLE OIL

CARBON STEEL 40/60 EMULSIFIABLE OIL

HARDENING AND TEMPERING 40/50 EMULSIFIABLE OIL

BEARINGS 40/60 EMULSIFIABLE OIL

SPRINGS 40/60 EMULSIFIABLE OIL

FOR TOOLS 30/40 EMULSIFIABLE OIL

FOR VALVES 35/50 EMULSIFIABLE OIL

STAINLESS STEEL 30/40 EMULSIFIABLE OIL

SPHEROIDAL GRAPHITE 20/40 EMULSIFIABLE OIL

CAST IRON 40/60 EMULSIFIABLE OIL

ALUMINIUM 80/600 KEROSENE

BRONZE 70/120 EMULSIFIABLE OIL

HARD BRONZE 30/60 EMULSIFIABLE OIL

BRASS 70/350 EMULSIFIABLE OIL

COPPER 50/720 EMULSIFIABLE OIL