Dakota Alert™ WR-3000 Wireless Receiver Owner’s Manual
WR-3000 RECEIVER INSTRUCTIONS WARNING This device complies with Part 15 of the FCC rules, operation of this device is subject to the following conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference, including interference that may cause undesired operation. Transmitter Module 8 5 3 4 2 } 2. WR-3000 Receiver } INTRODUCTION The WR-3000 receiver can be used with any of the Dakota Alert 3000 series transmitters (WMT-3000, WPT-3000, WHT-3000).
For maximum range between the transmitter and receiver, the receiver should be mounted horizontally on a wall and as high off the floor as possible. Although the maximum range is about 3000 feet, things such as hills, trees, metal siding and stucco can all reduce the range. CODING THE RECEIVER 1. Open the receiver case by inserting a small screw driver into one of the pry notches on the side of the case. 2. Gently lift off the front cover. 3.
. The channel 1 relay and the 12 VDC output can be set to operate for 4 seconds or 10 minutes. To change the duration, locate the jumper (8) on the upper right hand corner of the circuit board. When the jumper is covering both pins, the output time is 4 seconds. When the jumper is only covering one pin, the output time will be 10 minutes. TECHNICAL SUPPORT If you encounter any difficulty in the operation of this product after reading the manual, please contact us.
Dakota Alert, Inc. 109 W. Main St. P0 Box 130 Elk Point, SD 57025 Phone: (605) 356-2772 Fax: (605) 356-2584 Web: www.dakotaalert.
