INSTALLATION INSTRUCTIONS Page 2- WALL MOUNTED INSTALLATION INSTRUCTIONS Page 5- FLOOR STANDING INSTALLATION INSTRUCTIONS 1
INSTALLATION INSTRUCTIONS Wall Mounted HANG TRACK Hang tracks are installed into wall studs to securely mount the closet to the wall. The hang track height will determine how far the closet hangs off the ground. A hang track installed at 84" (to the center of the holes) off the ground will result in a full length upright (86½") just touching the ground. The top shelf will be 2½" above the hang track. Use this to determine where to mount the hang track. Install the hang track with the lips facing upwards.
8 dowels on the vertical panels. Once seated, secure the shelves with a screw driver by turning the cam a half turn in the clockwise direction. INSTALLING SHELVES Locksonto are designed to be turned withthe theshelves screw driver a slight cam locks onto the installed Shelving can Tip: nowThe beCam installed the uprights. Lower withatinstalled angle as to avoid hitting your knuckles on the vertical panel. dowels on the uprights.
CORNER BRACKETS - If Applicable Corner Brackets come in a pack of 3 and are designed to attach shelves perpendicularly to each other. Each pack of corner brackets includes wood screws to install the brackets to one of the shelves prior to installing the shelf. Attach the corner bracket using the supplied screws to the custom cut shelves on wall A. Next, install this shelf with the bracket attached, at the height of the adjacent shelf already installed on wall B to complete the corner.
INSTALLATION INSTRUCTIONS Floor Standing PLANNING & PREPARATION Use your order form to layout your uprights, shelves, and hardware in front of the location they will be installed. This will help to verify all of the items needed, as well as help to visualize the completed project. INSTALLATION Floor Standing Closets can be assembled either in place or assembled on the ground. Assembling in place is easiest with two people to install.
CUSTOM LENGTH SHELVING - If Applicable Some of your shelving may need to be cut to a custom length in order to create a wall-to-wall closet solution. To create a smooth, clean cut on your shelves, apply painter’s tape to the area you intend to cut & cut your shelves using a circular saw using a high tooth count (80 teeth is optimal) blade. Once shelves are cut to the custom length, use L-brackets to attach the cut edge to the upright.