Troubleshooting guide

MAN# 650016
2
in-line FUSE
RED: +12 BATTERY
BLACK: GROUND
YELLOW
WHITE
GREEN
BLUE
CHANNEL 4
CHANNEL 3
CHANNEL 1
CHANNEL 2
All channels must
be connected to
relays if they are
used.
PINK
PURPLE
BROWN
CHANNEL 7
CHANNEL 6
CHANNEL 5
ANTENNA,
DO NOT GROUND
DAKOTA DIGITAL
not used not used
GROUND
CH 1
CH 2
Wiring harness color code.
GREEN driver’s window up relay
RED constant 12 volt battery source
BLUE passenger’s window up relay
BLACK chassis ground
WHITE driver’s window down relay
YELLOW passenger’s window down relay
PINK or GRAY CHANNEL 7 relay (optional)
PURPLE CHANNEL 6 relay (optional)
BROWN CHANNEL 5 relay (optional)
The remote system output wires are negative switched outputs designed to turn on external
relays. These outputs can only handle 0.25 amps and must be used with a relay. Two dual relay
packs are supplied in the kit. To use all 7 channels you will need to purchase three additional
relays.
WINDOW CONTROL OPERATION
Each key chain transmitter has four buttons. Each button will activate its own independent
channel when pressed. Also, an additional 3 channels can be activated by pressing button 1 and
one of the other three buttons at the same time.
Button 1 activates the driver’s window up. The window will continue to move as long as the
button is held. Button 3 activates the driver’s window down.
Button 2 activates the passenger’s window up. Button 4 activates the passenger’s window
down.
Pressing buttons 1 and 2 at the same time can activate an external relay on Channel 5.
Pressing buttons 1 and 3 at the same time can activate an external relay on Channel 6.
Pressing buttons 1 and 4 at the same time can activate an external relay on Channel 7.
The emergency release switch can be wired to roll the driver’s window down to provide
emergency entry to the vehicle.