Troubleshooting guide

MAN# 650016
3
LOCK/UNLOCK OPERATION
Each key chain transmitter has four buttons. Each button will activate its own independent
channel when pressed. Also, an additional 3 channels can be activated by pressing button 1 and
one of the other three buttons at the same time.
Button 1 activates the door actuator to lock the doors. Button 3 activates the door actuator to
unlock the doors. The door actuator will remain powered for as long as the button is held. The
buttons should not be held more than a couple of seconds to avoid damaging the door lock
actuators.
Pressing button 2 can activate an external relay on Channel 2. This can be used for a trunk
latch release or other function.
Pressing button 4 can activate an external relay on Channel 4.
Pressing buttons 1 and 2 at the same time can activate an external relay on Channel 5.
Pressing buttons 1 and 3 at the same time can activate an external relay on Channel 6.
Pressing buttons 1 and 4 at the same time can activate an external relay on Channel 7.
Two additional wires will need to be passed through each door, along with the other power
window wires. This should be done using a flexible rubber tube or rubber grommet to protect the
wires, or by using the optional DAKOTA DIGITAL, INC. MAGNUM SHOOTERS. MAGNUM
SHOOTERS will eliminate the wires running through the door jambs entirely for the cleanest
appearance possible. When these highly conductive brass contacts are mounted to the door and
to the door jamb they eliminate the wires completely. If you would like to use MAGNUM
SHOOTERS they can be ordered directly from DAKOTA DIGITAL, INC. by calling toll free 1-800-
852-3228. Using either the flexible rubber tube, or MAGNUM SHOOTERS, route the remaining
wires under the dash for the best location and appearance.