User Guide

Manual #650574
12. The VHX side gauges are now ready to re-install into the factory cluster. Temp/Fuel will be
mounted on the left and Oil/Volt on the right; carefully route the ribbon cables through the
openings so they don’t get pinched. Secure the gauges using the same procedure as the stock
gauges with the factory screw clamping the bezel mounting bracket against the square nut.
11. For the side gauges, remove the stock lens and gauge face, fit the VHX system side gauges into
place making sure the noted top of the bezels matches the top of the VHX gauges and secure it to
the bezel reusing the two stock bezel mounting brackets and four screws.
13. Connect the supplied CAT5 cable to the rear of the system and route it along with the ribbon
cables through the already mounted jack cover, be careful not to pinch any of the cables.