LED Tail Lights for 1969 Firebird Installation Instructions

6. Pass the wires through the housing where the original bulb and socket were. Set the LED
assemblies into the housing so the studs extend out the hole in the bottom of the housing.
7. Feed the wires through the larger hole in the mounting plate. Guide the mounting plate to the
bottom of the housing. The flat side of the mounting plate should be down and the side with
the slight raised center should go up toward the housing. This will align the mount in the
original housing.
8. Slide the mounting plate over the two studs and tighten it down with the two #6 lock nuts. This
will secure the LED assembly into the housing, you are now ready for re-assembly.
9. Repeat the steps above for the second light.
10. Install the lens and reassemble the housing, insuring all gaskets are intact and in place.
11. Install the housing back into the vehicle.
MAN# 650201