- Dakota Digital, Inc. LED Tail Lights for 1970 Chevelle Installation Instructions

INSTALLATION INSTRUCTIONS

LAT-NR320

LED Tail Lights for 1970 Chevelle

MAN#650202

Kit Includes:

Installation:

1. Remove the tail light lenses. There are four screws holding each lens in.

2. Remove the tail light bulbs.

3. We recommended that the lens and housings be cleaned to insure proper mounting and

visibility of the LED assembly. If the lenses are in bad shape a new set is suggested.

4. DO NOT remove the tape from the led assemblies yet!

5. Test fit the assembly into the lens as shown below to make sure it aligns correctly.

6. Make sure you have BOTH lenses clean and dry so the single use primer applicator can be

used for both lenses. Apply the primer to the top and bottom edges of the lens where the tape

will attach. AFTER THE PRIMER HAS BEEN APPLIED, LET THE LENS DRY FOR 5

MINUTES BEFORE GOING ON.

MAN#650202

PAGE 1
INSTALLATION INSTRUCTIONS LAT-NR320 LED Tail Lights for 1970 Chevelle MAN#650202 Kit Includes: Installation: 1. Remove the tail light lenses. There are four screws holding each lens in. 2. Remove the tail light bulbs. 3. We recommended that the lens and housings be cleaned to insure proper mounting and visibility of the LED assembly. If the lenses are in bad shape a new set is suggested. 4. DO NOT remove the tape from the led assemblies yet! 5.
PAGE 2
7. Peel the backing off the tape for installation. 8. Carefully place the LED assembly onto the lens and press down firmly. 9. Insert the LED assembly bulb base into the tail light housing socket. 10. Fasten the lens back on with the four original screws. 11. Repeat steps 7 – 9 for the other side. 12. Test the tail lights, brake lights, and turn signals. If the turn signals do not flash you will need to upgrade your flasher.