- Dakota Digital, Inc. LED Tail Lights Installation Instructions

INSTALLATION INSTRUCTIONS

LAT-NR120

LED Tail Lights for ’62-‘64 Nova

MAN#650154

Kit Includes:

Installation:

1. Remove the tail light lens.

2. Remove the light bulb.

3. Remove the original bulb connector from the back side of the housing.

4. Now is a good time to clean or replace the lens and housing if necessary.

5. Remove the two screws and aluminum plate from the back of the new LED assembly.

PAGE 1
INSTALLATION INSTRUCTIONS LAT-NR120 LED Tail Lights for ’62-‘64 Nova MAN#650154 Kit Includes: Installation: 1. 2. 3. 4. 5. Remove the tail light lens. Remove the light bulb. Remove the original bulb connector from the back side of the housing. Now is a good time to clean or replace the lens and housing if necessary. Remove the two screws and aluminum plate from the back of the new LED assembly.
PAGE 2
6. Insert the new LED assembly through the hole where the original bulb and connector were. Be careful when feeding the wires through to avoid damaging insulation. 7. Feed the wires through the larger hole in the mounting plate. Guide the mounting plate to the bottom of the housing. The flat side of the mounting plate should be to the outside and the side with the slight raised center should go in toward the housing. This will align the mount in the original housing. 8.
PAGE 3
11. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 12. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below.