- Dakota Digital, Inc. LED Tail Lights Installation Instructions

ManualsBrandsDakota Digital ManualsWork LightLED Tail Lights LAT-NR160

INSTALLATION INSTRUCTIONS

LAT-NR160

LED Tail Lights for ‘64-’66 Chevelle, ’71-’72 Chevelle,

and ’66-’67 Nova

MAN#650158

Kit Includes:

Installation:

‘64 Chevelle ‘65 Chevelle ‘66 Chevelle ‘71-‘72 Chevelle ‘66-67 Nova

1 2 3

1. Remove the tail light lens.

2. Remove the light bulb.

3. Remove the original bulb connector from the back side of the housing. The housing may need

to be removed from the car on the ’71-’72 Chevelle.

MAN#650158

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS LAT-NR160 LED Tail Lights for ‘64-’66 Chevelle, ’71-’72 Chevelle, and ’66-’67 Nova MAN#650158 Kit Includes: Installation: ‘64 Chevelle ‘65 Chevelle 1 ‘66 Chevelle 2 ‘71-‘72 Chevelle ‘66-67 Nova 3 1. Remove the tail light lens. 2. Remove the light bulb. 3. Remove the original bulb connector from the back side of the housing. The housing may need to be removed from the car on the ’71-’72 Chevelle.
PAGE 2
4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Remove the screw and aluminum back plate from the back of the new LED assembly. LED assembly standard back back for ‘71-‘72 Chevelle (attached to the assembly) (packaged separately) 6. Insert the new LED assembly through the front of the tail light housing and align the LED assembly with the hole where the original bulb and connector were located.
PAGE 3
8. Secure the back plate with the supplied screw and washer. 9. Make sure the original lens gasket is in place and then replace the tail light lens. Tighten the screws down carefully.
PAGE 4
10. Start by cutting off the existing light socket as it will not be used. Do not strip wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below.