- Dakota Digital, Inc. LED Tail Lights Installation Instructions

INSTALLATION INSTRUCTIONS

LAT-NR230

LED Tail Lights for 1960-1972 Chevy Fleetside Pickup

MAN#650188

Kit Includes:

Installation:

1. Remove the two screws and tail light lens.

2. Remove the light bulb.

3. Push and twist to remove the plastic wire socket from the back side of the housing.

4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is

recommended.

5. Remove the nut and round metal spacer from the back of the new LED assembly.

MAN#650188

PAGE 1
INSTALLATION INSTRUCTIONS LAT-NR230 LED Tail Lights for 1960-1972 Chevy Fleetside Pickup MAN#650188 Kit Includes: Installation: 1. Remove the two screws and tail light lens. 2. Remove the light bulb. 3. Push and twist to remove the plastic wire socket from the back side of the housing. 4. Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended. 5. Remove the nut and round metal spacer from the back of the new LED assembly.
PAGE 2
6. Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation. 7. Feed the wires through the round metal spacer, with one wire going through each outer hole in the aluminum spacer. The larger diameter ring should be away from the tail light housing. Use caution when feeding the wires through to avoid damaging the wire insulation. 8. Secure the metal spacer with the supplied #6 nut. 9.
PAGE 3
10. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 11. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below.