- Dakota Digital, Inc. Motorcycle Accessories User's Manual

MAN#650302-A
MCL-3K-T and MCL-3K-T-R
Outside Air Temp
MCL-3000/3006 Instrument Packages
This gauge can replace any ONE of the original four small gauges in the Dakota Digital MCL-3000 and MCL-3006
products. Only one auxiliary gauge: Boost, Air temp, or Air pressure can be used at a time or the setup menus
will not function properly as the auxiliary gauge is number
8
88
8
in setup.
Remove the desired gauge where you will be installing the AIR TEMP gauge. The gauge will mount just as the
previous gauge, using the original hold down clamp with the supplied thumb nuts.
Wiring the gauge will be slightly different than before as the bike doesn’t have provisions for the new sensor.
Use the supplied sensor and wiring to make a jumper harness from the original plug to the new AIR TEMP gauge.
*DO NOT connect the factory connector direct to the gauge, use supplied wiring.
Connect the power and ground male spade terminal end into the original plug as shown.
The Red +12V keyed power connects to the Orange wire in the original plug.
The power wire for the gauge is the short single Red wire that has a male spade on one end and female
spade at the other.
The Black ground wire connects to the Black wire in the original plug.
The third terminal in the original plug is not used, that is the factory sender signal.
POWER
GROUND
SENDER
Original plug on bike
Original plug with jumper wires for
power and ground connected
RED wire
Ground
BLACK wire
Ground
SWITCH/DIM
PLUG

Summary of content (4 pages)