Owner's manual

DFX-8 Ultrasonic Thickness Gauge
31
3.8 GT3 – Menu
GATE3 WIDTH: This feature allows the user to set the overall width of the gate, in
terms of distance, from the starting value of HoldOff3. Refer to page 85 for further
info.
HOLDOFF 3: Provides the user with the ability to delay the starting point of Gate3, a
specific distance from the first detection point found inside of the boundaries of the
Gate 2 settings. If no detection is found, the Gate2 width value is used as a starting
value for Gate3. Refer to page 85 for further info.
THRESHOLD3: Enables the user to set the sensitivity level of Gate3. The amplitude
of the signal must reach or exceed the threshold level before a measurement is
detected. Refer to page 85 for further info.
3.9 SETUP – Menu
OPEN:
Displays a list of factory and user defined setups currently stored in memory.
These setups can be recalled and used at any time. Refer to page 158 for further
info.
SAVE:
Provides the user with the ability to save a custom setup that has been
modified or created by the user. Refer to page 160 for further info.
DELETE:
Provides the user with the ability to delete specific setups previously save
in memory. Refer to page 163 for further info.
DEFAULT SETUP:
Loads a basic default setup. Use only as a last resort when the
setups in the DFX-8 have been corrupted and a computer is not accessible. Refer to
page 165 for further info.
LANGUAGE:
Provides the user the ability to select different languages for the DFX-
8. Refer to page 167 for further info.