Instruction Manual

Dakota Ultrasonics
30
4.14 OK Key
The primary function of the OK key is confirmation of a change or selection.
Additionally, when the group data is being displayed, the OK key will allow the
user to advance the cursor to a specific bolt number in the group.
4.15 ESC Key
The ESC key is used in the MENU, MEAS, and EDIT functions as a back or
escape function. Additionally, when the group data is being displayed, the OK
key will allow the user to toggle the display view options: RF, RECT, and DIGITS.
4.16 Arrow Keys
The Arrow Keys are used to navigate through the menus, increase/decrease
values, and toggle specific function keys.
4.17 ENTER key
The ENTER key is used in the overall menu selection process, to activate list and
edit boxes, and save measurements to bolt group locations.
4.18 AUTO SET Key
The AUTO SET key attempts to locate the detection of the signal, or end of the
bolt. This key is used to activate two completely different functions:
1. Reference Lengths – When measuring reference lengths, will locate the
detection point (end of the bolt or target), and optimize the scope settings.