Assembly Instructions

End
Stop
Allen
Wrench
Hex
Bolt
Shelf
Support
Anti-Skid
Pad
End Frame
Top
End
Outer Side
(Smooth Seam)
Cross
Beam
Corner
Post
2 - End Frames (13.5”x30.375”)
6 - Shelf Supports (23.4”x.75”sq.)
12 - Triangular Shelving End Stops (1.25”x1.25”)
12 - Adhesive Shelving Anti-Skid Pads (.375”sq.)
12 - Allen Bolts (M6x30mm)
1 - Allen Wrench
Parts Included:
3 Shelf Steel Frame Kit
Assembly Instructions
Assemble unit on a carpet or flattened carton to
protect the unit and the floor from scratches.
NOTE: Shelf Units can be assembled without using Shelving End Stops by instead using
the Shelving Anti-Skid Pads
(see Step 5).
Step 3
Attach the other End Frame
to the assembled Shelf
Supports – using sets
of Hex Bolts and
End Stops.
Always make sure
the bottom of the End
Stops align with the
bottom of the Cross
Beams.
Step 4
Attach remaining Shelf
Supports to assembled
Frame Unit – using
sets of Hex Bolts
and End Stops.
Re-tighten all
Hex Bolts and be
sure End Stops
align with bottom
of Cross Beams.
Step 5
Apply Anti-Skid Pads
to the four corners of
each level as shown.
Step 6
Complete Shelf Unit by placing DAKOTA
(24”x11¾”)
Shelves
(purchased separately)
on the
various levels.