Owner's Manual

7
UK DE DK CN JP FR
NOTE: On some floor surfaces and in some rooms, the use of spikes is a crucial aspect in
obtaining the best result. The spikes (included) should be fastened loosely in the four aluminium
feet, leaving the spike’s nut only slightly tightened. Using the screws, mount the feet in the
threaded holes on the bottom of the speaker. Push the feet against the cabinet before tightening
the screws. Place the loudspeaker upright on its spikes on the floor, so that it stands steadily
without rocking. Tighten the nuts, so that the four spikes sit tightly in the aluminium feet.
These assembly and setup steps ensure stable mechanical coupling to the surface beneath
(see Figure 3).
3.2 DALI OPTICON 2
DALI OPTICON 2 is optimized for stand mounting, but will also work well on a shelf. If positioned
on a stand or shelf, the enclosed bumpers can be placed under the speaker for stable and
vibration-free positioning (see Figure 4).
3.3 DALI OPTICON 1
There are several placement options for DALI OPTICON 1; on a stand, on a shelf, on a table-top
or wall-mounting. For wall-mounting DALI OPTICON, you must use the included wall bracket.
Before mounting the speaker on the wall, position the special bumpers - enclosed in the wall
bracket packaging - on the bottom rear edge of the speaker (See figure 5). These bumpers
ensure the correct distance from the wall and ensure secure mounting. If positioned on a stand
or shelf, the enclosed bumpers can be placed under the speaker for stable and vibration-free
positioning (see figure 4).
3.4 DALI OPTICON VOKAL
DALI OPTICON VOKAL is the dedicated centre channel and has been specially designed to be
positioned close to the large surface of the TV screen. You can place it above or below the
screen, on a stand or on a shelf. We recommend fitting the enclosed bumpers to ensure a
stable, vibration free setup (see figure 6).
3.5 DALI OPTICON LCR
DALI OPTICON LCR is optimized for wall-mounting (see Figure 7), but can be used on a shelf
or TV furniture.
DALI OPTICON LCR can be used as a left, right or centre speaker. If used in the horizontal
position the hybrid tweeter module should be rotated so it stays vertical, which is important to
preserve the wide dispersion and fine detail of the high frequencies. If used in the horizontal
position, you can rotate the DALI logo on the front grille by lifting it up slightly and rotating it into
the desired position (see Figure 8).
The ribbon tweeters are pre-configured for vertical positioning in the factory and if the speaker
is used in the horizontal position, your authorized dealer or service facility can rotate the ribbon
tweeter for you. To remove the ribbon tweeter from the cabinet, use a 3 mm Allen key (not
included) to remove the four screws. When disassembled, rotate the ribbon tweeter 90 degrees.
Insert the rotated ribbon tweeter and install it, using the four screws (Figure 9). Be careful not
to over tighten the screws when assembling the speaker again.
If positioned on a shelf or TV furniture, the enclosed bumpers can be placed under the speaker
(in both the vertical or horizontal position) for stable and vibration-free positioning
(see Figure 4).