Operation Manual

8
Note: Make sure that the bare conductors are tightly gripped by the terminals with no loose
wires that could cause a short circuit and damage the amplifier (see figure 3A and 3B).
5.0 MOUNTING
The loudspeakers should ideally be positioned, so that the height of the tweeter is approximately
at ear height when seated in your favorite listening position.
5.1 DALI FAZON MIKRO
5.1.1 Shelf mounting
Placing the FAZON MIKRO upright on a flat surface, like a shelf or TV furniture do not require
the use of the supplied bracket. Mount the supplied pads on the bottom of the loudspeaker and
place it at the desired location (see figure 4).
5.1.2 Wall mounting
Mount the supplied bracket on the wall at the desired position (see figure 5). Attach the
loudspeaker to the bracket, and make sure the speaker cable is run along the sides of the
bracket (see figure 6A and 6B).
5.2 DALI FAZON MIKRO VOKAL
5.2.1 Shelf mounting
Slide the protective cap over the rounded end of the supplied bracket (see figure 7B). Attach
the bracket on the loudspeaker (see figure 7C).Mount the supplied pads on the bottom of the
loudspeaker and place it at the desired location (see figure 7A).
5.2.2 Wall mounting
Mount the supplied bracket on the wall at the desired position (see figure 5). Attach the
loudspeaker to the bracket, and make sure the speaker cable is run along the sides of the
bracket (see figure 8A and 8B).
6.0 RUNNING-IN
Like any mechanical system (e.g. a new car), a loudspeaker requires a “running-in” period to
perform at its best. You will experience a gradual increase in sound quality during the first period
of use. The break-in period will vary depending on use and playback volume (approximately 50
hours at medium volume is recommended). Unlike other mechanical systems, the life-span of
a loudspeaker is increased by normal, regular playback of music.
Note: NEVER place the DALI FAZON MIKRO with the front facing down without the grille, as this
will cause deformation of the silk dome tweeter, which may damage its performance.
7.0 CLEANING & MAINTENANCE
Clean the high-gloss lacquer with a soft, dry micro-fibre cloth. If the rubber-painted front baffle
is dirty, wipe with a soft, damp micro-fibre cloth. Be careful not to damage the 4” midrange
driver when wiping them, as they are very fragile. It is very important that you avoid wiping the
dome tweeter. When removed from the speaker baffle, the grille can be softly vacuumed and
wiped with a well-wrung, lint-free cloth using a mild all-purpose cleaner.