Operation Manual

10
11
Functions
EUPHONIA
AS2
Output terminals
The output terminals (Left & Right) provide a  ltered output signal with a crosso-
ver frequency of 70 Hz and cut off with a 2nd order high-pass  lter. This set of ter-
minals can be used if the subwoofer is used together with the speaker driven by a
separate ampli er, if you want only the frequency range over 70 Hz to be handled
here, e.g. to protect the speaker system against very low frequency content - low
frequencies which the AS 2 has been selected to deal with.
Other functions
The 'Power' button is the main switch for the system. You should switch off the
system completely when it will not be in use for long periods. When making or
changing connections, you must always switch off the system completely.
The 'Auto Shut Off' function places the AS2 in stand-by mode after 15 minutes
without a signal on the input. When the AS2 receives a signal again, the system
comes on automatically.
Overloading
If you often play very loud, you should be careful of any dissonance or distor-
tions. The AS2 is protected against short-term overloading, but if you oftentend to
overdrive the system, you should use a permanently lower setting on the volume
level control on the AS2. Repeat any phase adjustment to improve the connection
between the front speaker and subwoofer. It may be this  ne adjustment which
provides the desired deep bass level.