User Manual

UK DE DK

9.3 STEREO CONNECTIONS

If you want to use DALI IKON SUB in a stereo setup, your stereo (pre-) ampliﬁer/receiver should

have either a set of stereo RCA line outputs or a mono RCA line output available (please refer

to the instruction manual of your stereo (pre-)ampliﬁer/receiver). The line output connector(s) of

your stereo (pre-)ampliﬁer/receiver must be connected to the LINE INPUT connectors (L+R) of the

subwoofer via one or two RCA cables (sold separately).

9.4 SURROUND SOUND CONNECTIONS

9.4.1 LINE INPUT

Use the LINE INPUT connectors L or R if you want to adjust the subwoofer frequency output using

the DALI IKON SUB crossover control.

To use this option, connect the subwoofer output connector(s) of your surround sound (pre-)

ampliﬁer/receiver with the LINE INPUT connectors on the subwoofer using an RCA cable (sold

separately). If the surround sound (pre-)ampliﬁer/receiver has only one subwoofer output

connector, connect it to the LINE INPUT L connector (white) of the subwoofer using an RCA cable.

Please refer to chapter “9.6 Installing and Adjusting” for instructions on how to make the adjustments.

9.4.2 LFE INPUT

Use the LFE input connector (red), if you want to adjust the subwoofer output from your surround

sound (pre-) ampliﬁer/receiver. When the LFE input connector is used the built-in crossovers are

bypassed and the crossover control will no longer function.

To use this option, connect the surround sound (pre-) ampliﬁer/receiver subwoofer output to the

LFE input connector on the DALI IKON SUB with an RCA cable (sold separately).

Please refer to the instruction manual of your surround sound (pre-) ampliﬁer/receiver on how to

adjust the crossover settings.

9.5 USING TWO DALI IKON SUBWOOFERS

In most cases you will achieve excellent results with one DALI IKON SUB. Use of two subwoofers is

possible as a no-compromise stereo solution, or for reproduction of very powerful sound pressures

in a stereo or surround setup in larger rooms.

The connections are basically the same as stated in previous chapters, but for stereo setup you

should only connect the left channel output connector of your stereo or surround (pre-) ampliﬁer/

receiver to the LINE INPUT L connector on the DALI IKON SUB placed to the left in your room. In

a similar way you should connect the right channel output connector of your stereo or surround

(pre-) ampliﬁer/receiver to the LINE INPUT R connector on the DALI IKON SUB placed to the right

in your room.

For a surround setup, split the output signal from your surround sound (pre-) ampliﬁer/receiver

using a RCA splitter (sold separately) and connect the two outputs. In all other respects, follow the

instructions above - but use separate channels. Please consult your authorised DALI dealer if you

have further questions.