User Manual

9
UK DE DK
3.1 DALI IKON 5, 6, 7
The speakers are designed to stand on the floor, using spikes or rubber bumpers under the
speakers, (see Figure 3+4). Be careful not to over tighten the contra nuts. Spikes or rubber
bumpers can improve the sound quality. You can try both to hear what gives the best sound quality
in your setup. Please be aware that spikes may damage the floor if it is not protected.
NOTE: On some floor surfaces and in some rooms, the use of spikes is a crucial aspect in obtaining
the best result. The spikes (included) should be fastened loosely in the four aluminium feet, leaving
the spike’s nut only slightly tightened. Using the screws, mount the feet in the threaded holes in
the bottom of the speaker. Push the feet against the cabinet before tightening the screws.
Place the loudspeaker upright on its spikes on the floor, so that it stands steadily without rocking.
Tighten the nuts, so that the four spikes sit tightly in the aluminium feet. These assembly and
setup steps ensure stable mechanical coupling to the surface beneath (see figure 3).
3.2 DALI IKON 2
DALI recommends that you place your IKON 2 on a stand for the optimum sound experience.
Alternatively, IKON 2 can be placed on a shelf with a min. 5 cm distance from the rear wall.
The enclosed rubber bumpers can be mounted under the speaker for stable and vibration-free
positioning (see figure 4).
3.3 DALI IKON 1
There are several placement options for DALI IKON 1: on a stand, on a shelf, on a table-top
or wall-mounting. For the best possible sound, we recommend placing the speaker with the
tweeter module at roughly the same height as your ears when you are seated in your favourite
listening position.
For wall-mounting DALI IKON 1, you must use an optional wall bracket (available at all DALI
dealers). Before mounting the speaker on the wall, position the special bumpers - enclosed in
the wall bracket packaging - on the rear edge of the speaker. These bumpers ensure the correct
distance from the wall and ensure secure mounting.
If positioned on a stand or shelf, the enclosed bumpers can be placed under the speaker for stable
and vibration-free positioning (see figure 4).
3.4 DALI IKON VOKAL 2
DALI IKON VOKAL 2 is the dedicated centre channel and has been specially designed to be
positioned close to the large surface of the TV screen. You can place it above or below the screen,
on a stand or on a shelf. We recommend fitting the enclosed bumpers to ensure a stable, vibration-
free setup (see figure 5).