Operation Manual

16
Adjusting the crossover frequency (only
when using ”LINE IN, Left/Right” inputs)
Once the volume level is fi nalised, you can start
on the equally important adjustment of the over-
lap between the front loudspeakers and the IKON
S
UB. To do so, adjust up and down using "Cros-
sover" until you can hear that the bass is even
and with no drop-out. You may have to adjust the
volume again.
Setting phase
Try different settings – if necessary combined
with new adjustment of volume and crossover
frequency. Select the position that provides the
smoothest transition between the main speakers
and the subwoofer. The choice may be diffi cult,
but it often pays to experiment extensively in your
search for the best sound. In any event, it is a
good idea to listen to the system for a few days
before making any fi nal adjustments. Using the
same setting for surround and 2-channel stereo
does not always achieve the best results. It is the-
refore a good idea to note the setup you prefer for
surround and stereo.
Selecting Auto function
The "Auto" function puts the IKON S
UB into
stand-by after approx. 10 minutes with no signal
received at the input. When IKON S
UB receives a
signal once more, the subwoofer’s amplifi er starts
up automatically.
The "Power" button is the main on/off switch. We
recommend switching off the system when it is
not to be used for long periods. When connecting
or changing connections, always disconnect the
main electricity.
Overloading
If the IKON S
UB is seriously overloaded, the built-
in safety circuit will cut the power off. If this oc-
curs, turn the system down and the IKON S
UB will
automatically come on-line again after a short
period.
The built-in safety circuit is not a guarantee
against damage as a result of overloading, which
is why the recommendations regarding sound
pressure etc., to be found on page 18 should be
followed.