User's Manual

21
IMPORTANT INFORMATION ABOUT THE SAFETY REVERSING SENSOR
The safety reversing sensor must be connected and aligned correctly before the garage door
opener will move in the down direction.
The sending sensor (with an red LED) transmits an invisible light beam to the receiving sensor (with a green LED). If an
obstruction breaks the light beam while the door is closing, the door will stop and reverse to the full open position, and the
garage door opener lights will flash three minutes
NOTE: For energy efficiency the garage door opener will enter sleep mode when the door is fully closed. The sleep mode shuts
the garage door opener down until activated. The sleep mode is sequenced with the garage door opener light bulb; as the light bulb
turns off the sensor LEDs will turn off and whenever the garage door opener lights turn on the sensor
LEDs will light. The garage
door opener will not go into the sleep mode until the garage door
opener has completed 5 cycles upon power up.
When installing the safety reversing sensors check the following:
· Sensors are installed inside the garage, one on either side of the door.
· Sensors are facing each other with the lenses aligned and the receiving sensor lens does not receive direct sunlight.
· Sensors are no more than 6 inches (15 cm) above the floor and the light beam is unobstructed.
Install The Photo Eye Safety System
1 Install the Safety Reversing Sensors
The safety reversing sensors can be attached to the the wall, The sensors should be no more than 6 inches (15 cm) above the floor.
HARDWARE
Invisible light beam
protection Area
Safety Reversing Sensor
6”(15cm)max.above floor
Screw M4×8(4)