User's Manual

WARNING

2 Wire the Safety Reversing Sensors

Power

1 Connect power

To prevent possible SERIOUS INJURY or DEATH from electrocution or ﬁre:

· Be sure power is NOT connected to the opener, and disconnect power to circuit BEFORE removing cover

to establish permanent wiring connection.

· Garage door installation and wiring MUST be in compliance with ALL local electrical and building codes.

· NEVER use an extension cord, 2-wire adapter, or change plug in any way to make it ﬁt outlet. Be sure the

opener is grounded.

1.1 Install the sensors to the mounting

bracket using the screws.

1.2 Position the mounting

racket against the wall

with the curved arms facing the door. Make sure

there is enough clearance for the beam to be

unobstructed. Attach the mounting bracket to the

wall using lag screws.

Mounting Bracket

Not provided

No more than 15cm

2.1 Strip 7/16 inch (11 mm) of insulation from

each set of wires. Separate the wires. Twist the

white wires together. Twist the white/black wires

together.

2.2 Insert the white wires into the

#1 terminal on the garage door

opener. Insert the white/black wires

into the #2 terminal on the garage door

opener.