User's Manual

To avoid installation difﬁculties, do not activate the garage door opener at this

time. To reduce the risk of electric shock, your garage door opener has a grounding

type plug with a third grounding pin. This plug will only ﬁt into a grounding type

outlet. If the plug doesn’t ﬁt into your outlet, contact a qualiﬁed electrician to install the

proper outlet.

THERE ARE TWO OPTIONS FOR CONNECTING POWER:

Option A TYPICAL WIRING

1.1A Plug in the garage door opener into a grounded outlet.

1.2A DO NOT run garage door opener at this time.

Option B PERMANENT WIRING

If permanent wiring is required by your local code, refer to the following procedure.

To make a permanent connection through the 7/8" hole in the top of the motor unit (according to local code):

1.1B Be sure power is NOT connected to the opener, and disconnect power to circuit.

1.2B Remove the garage door opener cover and set aside.

1.3B Remove the attached green ground terminal.

1.4B Cut black and white wires and strip away 1/2" (1 cm) of insulation, 6" (15 cm) before spade terminals.

1.5B Remove the power cord from opener.

1.6B Knock out the hole plugs above 7/8"hole.

1.7B Install a conduit or ﬂex cable adapter to the 7/8" hole

1.8B Run wires through conduit, cut to proper length and strip insulation.

1.9B Attach with wire nuts provided. Attach the ground wire to the green ground screw.

The opener must be grounded.

1.10B Properly secure wire under plastic ties so that wire does not come in contact with moving parts.

1.11B Reinstall the cover. DO NOT run garage door opener at this time.

2 Ensure the Safety Reversing Sensors are aligned

The door will not close if the sensors have not been installed and aligned correctly

When the light beam is obstructed or misaligned while the door is closing, the door will reverse and the garage door

opener lights will ﬂash three minutes. If the door is already open, it will not close.

RED

REE

LED